How to install HPA Infinite v2 conversion kit for AAP-01

1

Place your replica (without the magazine) upside down on a stable surface. Then, position the provided cutting template "IF-D2" in the same orientation as shown in the image until it reaches the stop of your replica (maximum).

2

Ensure that the cutting template is securely held in place, then start cutting the two designated markers using a utility knife or scalpel, gradually progressing until reaching the two small horizontal lines at the bottom of the template.

Keep in mind that surpassing these lower lines will not affect the subsequent installation.

Important: Use protective gloves during this process!

3

To complete the cut entirely, fold the tab and make an incision at the fold to fully remove the piece.

4

Pull the bolt back to activate the replica's hammer, then remove the upper receiver.

5

Insert the Infinite kit completely until it reaches the maximum stop of your replica.

6

Secure the assembly by gently tightening the screw using the 2.5mm hex key.
Screw it firmly until the screw reaches the surface of the lower frame.

7

Tighten the two screws using the 2mm hex key.
Screw them firmly to ensure the kit is securely assembled onto the hammer block.

8

To complete the installation, reattach the upper receiver.