Comment changer de module pour passer de Glock à AAP-01 avec le kit Infinite v2

How to upgrade from Glock to AAP-01 with the Infinite v2 kit

Do you want to adapt your Infinite V2 Glock kit to your AAP-01?

Nothing's easier! In this guide we explain in detail how to do this.

This tutorial, designed to transition from Glock to the AAP-01, can also be applied in the other direction, providing a simple method for transitioning between the two models!


Required for installation(included) :

  • IF-11A conversion module (AAP-01 version)
  • Installation set

Important :

Always wear protective eyewear when handling airsoft products.

Step 1: Disassembly of the Glock Module


Using a 2mm hex key, remove the bottom module of the kit by unscrewing the two screws that secure it.


Remove the final module by bending the air line if necessary to ease the extraction.

Step 2: Installing the IF-11 AAP-01 module


Bend the air line as instructed, then insert the replacement module for AAP-01, ensuring the correct orientation.

Important: Place only two 0.5mm shims (provided) at the front as indicated before installing the module.


Insert the final module and secure the assembly using the screws.

Important: Do not tighten the screws too much initially to facilitate easy installation in your next replica.


Replace the cover and rubber seal with the ones compatible with the AAP-01 if necessary.

To do so, remove the steel pin and unscrew the two screws using a 1.5 mm hex key.


Insert a coupler into the HPA hose.

All that's left is to install the kit into an AAP-01!

Check out the tutorial: Here.

Congratulations! The installation is now complete.
Thank you for following our installation guide.
Do not hesitate to consult our FAQ in case of difficulties or if you need additional assistance.

Leave a comment

All comments are moderated before being published.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.