Comment installer le kit Infinite V2 dans une Lower frame CTM

How to install the Infinite V2 kit in a CTM Lower frame

Do you want to adapt your Infinite V2 kit to a CTM lower frame?

Nothing's easier! In this guide we explain in detail how to do this.

Information :

Hardware required for installation :

  • 2mm hex key
  • M3x6mm screw

Important :

Always wear protective eyewear when handling airsoft products.

Lower frame CTM

1

Information: After making the modification for the HPA line passage, drilling will not be required when using CTM grips. You can proceed directly to the next explanation.

Reminder: If you want to review the step for the HPA line passage, here is the link .

2

Replace the CTM-supplied screws (highlighted in red) with M3x6mm screws.

3

Information: Once the screws are secured in the lower frame, they will hold the kit in place at the green-marked location above.

4

Congratulations, the installation is complete.

Thank you for following our guide.
Do not hesitate to consult our FAQ in case of difficulties or if you need additional assistance.

Leave a comment

All comments are moderated before being published.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.